VICTORIAN MANSION UNDER CONSTRUCTION HO (1/87th) SCALE - FIRST FLOOR
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
This is part one of a four part build.
- Rating
- 0 / 5
- Likes
- 49
- Downloads
- 170
- Makes
- 0
- Views
- 1,318
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other Ideas
- License
- Creative Commons — Attribution
This HO scale (1/87th) VICTORIAN MANSION is to look like it is under construction. The model at this posting is for the first floor only. Depending on your printer, some components may require some minimum minor trimming.
Commercially produced 4'x8' plywood flooring wasn't produced in this country until 1927. So the flooring boards are solid lumber and in a real construction site they would be installed on the flooring joists before the walls were built. I use index card stock to represent the flooring, saves many hours of printing time. Stairs are not detailed.
I exclusively print with PLA and have found that ordinary clear lacquer thinner (Nail polish remover) is a wonderful glue. Make a small test for yourself of two printed pieces of scrap PLA and give it a try. Let sit for 20 seconds and then try to break it apart. It leaves no residue and is applied with a small brush. I've been using lacquer thinner as a glue on stryene and PLA for years. No sloppy or messy glue to show when finished.
If you would like me to design a custom model for you contact me at:
It is totally free, but I will post it on Prusa Printables for others to print and enjoy.