Amiibo Stands for Full Amiibo Collection

I printed about 250 of these on my Prusa MK3S+.

I found the best results came from using Monoprice PLA (https://www.monoprice.com/product?p_id=15835).

I used 0.2mm layer height on SPEED setting in PrusaSlicer. 

For all stands: 215C, 7% grid infill. 

For the rods: 215C, 20% grid infill. 

The most common issue I had was the corners of the bottom shrinking slightly and pulling away from the bed, but it was typically very subtle. I think there was literally only one stand that I decided to reprint due to it.

Overall cost of stands for every single amiibo was ~$150 of filament and it took about a month of running the printer ~20hrs per day to finish. 

For most amiibo, use the “standard” stands.

For the Skylander/Amiibos (DK and Bowser), use specifically their stands (square_skymiibo_*).

For the monster hunter amiibos (which are quite wide), use the “wide_” stands. You might want to use one for the Guardian (BOTW) as well, but I found he actually fit on a standard stand. YMMV.

For loot goblin, use his stand ("loot_goblin_*"). 

For the cards, use the card stand. 

For the yarn amiibos (yoshis and the pup), use the “square_hole_” stands. 

For mega yarn yoshi, you're on your own. I just left him in his box.