Keystone Surface Mount (single)
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
This is a remix of jsadusk's thing with added mounting flanges for use in my Tinker Friendly Ikea Lack printer…
- Rating
- 0 / 5
- Likes
- 10
- Downloads
- 143
- Makes
- 0
- Views
- 736
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Electronics
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
This is a remix of jsadusk's thing with added mounting flanges for use in my Tinker Friendly Ikea Lack printer enclosure. These make it very easy to disconnect/reconnect the case leds, spotlight, mixing fans, cooling fan, and filament run out sensor that are mounted on the removable enclosure top. It requires 2@ #8 wood screws and of course a cat6 keystone jack to complete.
The original blank design was about 1mm too small for my Keystone jacks. So they wouldn't fit at all, even with some trimming with a razor. So I also adjusted the fit with this remix. Keystones now snap in fairly easily. There is a resulting small gap on 2 sides of the keystone's face once installed, but it's barely noticeable and they still hold very securely.
Category: Electronics