Bambu X1C Straight Poop Chute

I have my X1C on a low table with plenty of room for bin to collect filament ‘poop’ on the floor behind the table. However, I did not want to push the X1C to the back of the table as it would somewhat restrict the access from the front. Therefore, this file allows for a straight chute to guide the ‘poop’ straight back to the table edge and into the bin below. It allows the printer to be about 50mm away from the back edge of the table. It is a straight forward print with spots for three 8mm diameter by 3mm thick magnets to hold the chute onto the printer. The part does not need strength so you can get away with minimal infill. I used 3 perimeters, but 2 would probably work ok as well.