OpenHAB Raspberry Pi 4/3 Case

The OpenHAB Raspberry PI Case is a clean and simple case for a Raspberry that is used as a hub in your smart home system.
Traditional 3D printable cases have normally all ports exposed and therefore always a messy look then there are cables connected.
This case has no visible screws, the cables are leaving the case at only one place at the bottom and it uses a french cleat system for mounting at a wall.

Print instructions

Bill of Materials:

• 8x M3 nuts
• 4x M3X20 screws
• 4x M3X12 screws
• 1x cable tie

Print Instructions:

• Supports: No
• Material: PLA
• A pause has to be added at 16.50mm for the top of the case to add the nuts to the print

Notes:

• I'm printing with an MK2S MMU1, because of that the parts with different colors are single parts. If you have problems to import them: https://help.prusa3d.com/en/article/importing-multi-material-model_121191
• I added to kinds of bottom parts. I personally use a flat LAN cable, but there's also offered one model that should work seamlessly with a round LAN cable
• The cable tie I used was one that came with my printer

I'm personally using a Raspberry Pi 4 in my case, but a Raspberry Pi 3/3B should fit too.