1 / 1
M.A.D. CR Touch Spacer for Biqu H2 V2S Revo — image 1

M.A.D. CR Touch Spacer for Biqu H2 V2S Revo

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

4.5mm spacer to move the CR Touch down for the longer nozzle of the H2 Revo

Rating
5 / 5
Likes
14
Downloads
143
Makes
2
Views
607
Reviews
1

Updated at source:

Model information

License
Creative Commons — Attribution — Noncommercial — Share Alike

When I added the CR Touch mount to my H2 Revo, the distances were off.  If I had it upside down, the probe sat well below the nozzle, but right side up, it was too high, and my nozzle crashed into the build plate.  I played around with a few different combinations of nuts and washers until I found that 4.5mm was perfect for my setup, and made this spacer really quick so that it didn't look so janky with nuts and washers as spacers.  I may remix the actual CR Touch mount to not need a spacer for my configuration, but until then, this works like a charm!

Printed in ASA for heat resistance and durability.  Settings don't matter much, as it's just a spacer.  So long as the holes line up, and it's the right thickness, you should be fine!

 

Disclaimer: Your printer may be (and likely is) different than mine, so it is up to you to figure out what your ideal spacing is, and scale the spacer accordingly!  Double check your measurements before you trust someone else's work!

Tags