Icing template for Tarte Camino se Santiago (Spanish almond cake)
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Profile hugging shield for casting icing sugar on a cake, leaving bare the shape of the Cross of Santiago (St James).
- Rating
- 0 / 5
- Likes
- 5
- Downloads
- 142
- Makes
- 1
- Views
- 784
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Kitchen
- License
- Creative Commons — Attribution — Noncommercial
A Tarte de Santiago or Spanish almond cake is covered with a thin layer of icing sugar, but with an uncovered image of the “Cruz de Santiago”. The top surface of the tarte can be quite uneven, requiring a flexible paper stencil to follow the surface contour. The template is normally cut from paper, but intricate shape of the cross requires some careful drawing and cutting.
This stencil has internal hinges that allow the template parts to bend and follow to the contour. The cross shape and hinge parameters are calculated in cadquery, then exported to STL.
Requires no support and the internal hinges print in place. After printing the hinges may require careful 'unlocking' to break potential small internal filament touching, afterwards they move freely.
The printer and filament profiles must be set up carefully, there are quite small clearances in the model. If it comes to the worst, the hinges will just be locked up, but all my prints so far loosened up after printing.
Be careful with the first layer - there are some small areas which requires good first layer discipline. Some filament products did not print well. Artillery PLA printed with no problem.
The cake picture shown here is taken from https://www.neighbourfood.ie/products/armelles-kitchen-santiago-tarte-10-inch/16542.
Cake recipe: https://www.carolinescooking.com/tarta-de-santiago/
https://en.wikipedia.org/wiki/Tarta_de_Santiago