New First Layer Calibration
We calculate the final price from your selected file. You review and accept it before payment.
Estimated printing price per file
€0.17 – €0.21 net (excluding VAT)
For file: 1stLayerTest_0.2mm_PLA_MK3S_16m.gcode
This is an estimate for one file. You’ll confirm the exact price before ordering.
File and estimate settings
File used for this estimate
Average indicative estimate: €0.19 excluding VAT (range midpoint).
- Weight reported by the author
- 1 g
- Print time reported by the author
- 15.6 min
- Source material
- PLA
- Estimate material
- PLA
- Estimate printer
- Bambu Lab P1S - 0.4 nozzle
- Estimate process
- 0.20mm Standard
Indicative estimate for the selected file only, based on the author’s weight and print time. File variants are not added together. The final price is calculated after file analysis.
Saved on this device.
This first layer calibration test focuses on the second layer.
- Rating
- 5 / 5
- Likes
- 44
- Downloads
- 206
- Makes
- 2
- Views
- 1,698
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Test Models
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
While the standard first layer test evaluates the surface, this test evaluates the second layer from the backside.
The closer the nozzle is to the bed, the more the second layer will assimilate with the first layer, and we aim to target for a distance just short of this not assimilating with the first layer. I think it would be easier to understand the specific state to aim for, and easier to adjust.
In images A and B below, the second layer has assimilated with the first layer, and C has begun to assimilate. I think a little before C is best. (In a typical Fast Slayer calibration test, everything from B-E is in the proper range).
The goal of this test is to get the same results in all 9 spots.
Print instruction
- Print settings: 0.20 QUALITY
- Filament: PLA
- Sheet: Smooth PEI sheet recommendation
Notes:
- Do not do this with filaments other than PLA, the state of the 2nd layer will change.
- This test is aimed at those who wish to pursue the z calibration. For others, we recommend testing as before.
My Other Test Model:
Practical Overhang Test - https://www.printables.com/model/327913-practical-overhang-test
