Scrappy Pump Station
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A frame piece utilizing a 24v Pump. Handy for sucking air from filament bags and inflating pool toys.
- Rating
- 0 / 5
- Likes
- 4
- Downloads
- 9
- Makes
- 0
- Views
- 215
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other Gadgets
- License
- Creative Commons — Attribution
This is a model I made to hold the electronic pieces for a little electric pump station I decided to make on a whim. All angles on the model except the knob opening are less then 60° with most kept as close to 45° as possible so supports should not be needed. The screw holes for the control board were left out of the model since the screws I had on hand were too small to make a vertical hole for so I advise just drilling them out holes for your use case and using whatever screws you have laying around like I did.
Anyways here is the additional hardware you need such as the pump:
Various Screws
In terms of assembly you need to slide the power adapter in backwards. It is a bit snug though so it will take some wiggling to get it in Fully. I advise you get all the wiring for the adapter and board set up prior to assembly as well since It can be a bit of a squeeze to get it all together. Finally the pump needs something to keep it on the frame, I used a ziptie and rubber band which seems to work well enough.