Trek Remedy Lower Shock Mount Offset Hardware
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Lower Shock mount spacers for replacing the rear shock with a bearing mount shock.
- Rating
- 0 / 5
- Likes
- 2
- Downloads
- 17
- Makes
- 0
- Views
- 246
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Outdoor Sports
- License
- Creative Commons — Attribution — Noncommercial — NoDerivatives
Lower Shock mount spacers for replacing the rear shock with a bearing mount shock.
Use these as a guide for space before getting them machined from stainless steel or aluminium
Its Offset hardware, one side shorter than the other, which is needed for the Remedy.
The base diameter is 22mm on both
The 22mm part is 2mm thick on both
The bore is 10mm
The top tube is 15mm diameter
Overall height of part A is 7.8mm
Part B is 16.8mm
When you test for size and machine these parts -
Replace the bearing mount shock bearings( 22x8x8 ) with 22mm x 10mm x 6mm,
I pressed these into the Bearing mount after removing the originals, and press the 22mm part into bearing housing, not fully in, little by little until the fit was right in the frame.
I used a vice and a socket to press in the shock hardware.