Menorah V3

A “wearable” Chanukah menorah using led pads, a 10way dil switch, 1.5 -5v booster board and a AAA battery. set on a bit of 3mm ply to sit in the top pocket of a shirt and switch on as required… the shamus or 9th light is connected to switch 10 as it always goes on first… the rest 1-8 9 is not used. I connect all the +ve sides of the led pads and switch the -ve sides . Once you've tested it the back is glued to the front, then it's held in place on the ply with a “hinge” using hot glue so the front sits over the top of the pocket..the battery holder hot glued on the bottom keeps everything square. It's printed at 15% infill , the front is thin, the leds show through the holes and the body, which is why you need the back on to reduce reflection….I can add a circuit diagram if something doesn't make sense.