Christmas Tree Stand
We calculate the final price from your selected file. You review and accept it before payment.
Estimated printing price per file
€8.28 – €10.13 net (excluding VAT)
For file: Stand - Waterproof_0.17mm_PLA_MINI_9h47m.gcode
This is an estimate for one file. You’ll confirm the exact price before ordering.
File and estimate settings
File used for this estimate
Average indicative estimate: €9.20 excluding VAT (range midpoint).
- Weight reported by the author
- 103 g
- Print time reported by the author
- 9.79 hr
- Source material
- PLA
- Estimate material
- PLA
- Estimate printer
- Bambu Lab P1S - 0.4 nozzle
- Estimate process
- 0.20mm Standard
Indicative estimate for the selected file only, based on the author’s weight and print time. File variants are not added together. The final price is calculated after file analysis.
Saved on this device.
Tripod stand suitable for small to medium trees, up to about 7 feet tall.
- Rating
- 5 / 5
- Likes
- 17
- Downloads
- 197
- Makes
- 0
- Views
- 1,214
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Home Decor
- License
- Creative Commons — Attribution — Noncommercial
Bill of Materials
- 1x Reservoir (printable)
- 1x Watertight reservoir liner (printable)
- 3x Legs (printable)
- 3x 3/8 x 4-½ eye bolts with 3/8" hex nuts
Printable parts can be modified in OnShape: https://cad.onshape.com/documents/8ffd204332ab341e7d85de26/v/153a3e1cc4ade9f9d1a56e3c/e/f161ebcfd918b70f6988b787
Comments
Since I'm printing in PLA instead of PETG, I was concerned about brittleness in the design and I think I've used quite a bit more filament than is strictly required. I think there is the potential for the amount of filament to be reduced a lot by reducing infill percentages and decreasing thicknesses of the printed parts. Printing in PETG would likely make it possible to reduce it further without risk of shattering.
Would love to see forks of the OnShape models! https://cad.onshape.com/documents/8ffd204332ab341e7d85de26/v/153a3e1cc4ade9f9d1a56e3c/e/f161ebcfd918b70f6988b787
Assembly Instructions
- Slide the legs onto the mount points in the Reservoir
- Optionally add foam or felt pads to the ends of the legs and underneath the Reservoir
- Insert the Waterproof reservoir liner into the Reservoir
- Slide the 3/8" hex nuts into the slots above each leg attachment point on the Reservoir
- Screw the 4-½" eye bolts into the hex nuts
References
Edits
- I had originally licensed this to allow commercial use, but I've since realized that this is not compatible with my use of OnShape.