Spritz Cookie Dies

Was bored and wanted some new shapes for my cookie press. One can handle only so many Christmas trees. I ended up making four, though the helicopter one is mostly a fail. The M. Falcon and R2 unit come out pretty good with one and a half squeezes. The Hashtag works fine.

They are designed to fit my Wilton Cookie Pro Ultra II. I'm pretty sure they will fit most cookie presses made in the last ten years.

11/11/15 Redesigned the helicopter die. Not perfect, but, it resembles one a little better.

02/18/19 Someone asked me to try and design a Sea Turtle. There were a few redesigns after absolute failures. I've posted the two that seem to look the best for me, I tend to make a stiff dough when I make these cookies. I think if I had had Design 4 ready when I made the cookies with Design 3 they would have looked better. The dough sat at room temp for over an hour while I redesigned and printed #4, so it was a bit softer. Let me know if y'all have any luck with these. Design 3 cookies are pictured on the cookie sheet, design 4 are on the paper plate with the die.

Print Settings

Rafts:

No

Supports:

Resolution:

.15mm

Infill:

Notes:

Each one took about 1.5 meters of 1.75mm filament. I'm sure they would print fine at .2mm resolution.

Post-Printing

Washing

Category: Kitchen & Dining