1 / 2
Ergonomic SAPI Plate replica
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
These are hollow SAPI plate replicas to use with airsoft vests etc.
- Rating
- 5 / 5
- Likes
- 91
- Downloads
- 826
- Makes
- 1
- Views
- 3,202
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Props
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
These are replica SAPI plates to use with airsoft vests, weight vests etc. You can either leave them hollow to give only stiffness or fill them up(I used finishing sealant) to get some weight. The front/back plate is about the size M plate and weights 1,4kg when filled with the finishing sealant. Large parts should be able to be printed on standard Ender 3 bed going from corner to corner. I have added 0.5-1cm extra area in firmware but I don't remember if it was needed for this.
Following materials are needed
Front/Back plate:
- 4x m6x20 bolts, and nuts
- 8x m6 washers (recommended)
- about 600ml of filler (optional)
Side plate:
- about 150ml of filler (optional)