Stand for Magic Keyboard / Magic Trackpad (1 location)
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Why I created support?
- Rating
- 5 / 5
- Likes
- 17
- Downloads
- 177
- Makes
- 2
- Views
- 970
- Reviews
- 2
Updated at source:
Model information
- Source
- Printables
- Category
- Computers
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
Why I created support?
I wanted to be able to put my Magic Keyboard vertically on a support but I could not find any model, this in order to make room on my desk to be able to use the most space to be able to work.
So I created my own support and I hope you like my work
Publish
I would be delighted if you took pictures of the impression of my work.
PRINT CONFIGURATION
I did a print test with a filling of 70% and it was good, but I advise you for an optimal result to make a filling of 90% or even 100%
For the layer height I advise you to make0.15mm but 0.20mm should be good too, it will depend on your desire to have a logo and smooth border or not
YOU ARE LOOKING FOR A MODEL WITH TWO LOCATIONS ?
You can find other version with two locations here
Changes
07/06/2020
Add logo on second walls
09/06/2020Center Logo
- Add version : Round edge 5mm
- Add version : Round edge 10mm
- Add version : Round edge 5mm with no wall edge rounds
- Add version : Round edge 10mm with no wall edge rounds
- Add version : Without any edge
Print instructions
Unassociated tags: Magic Keyboard
Category: Computer Summary
Why I created support?
I wanted to be able to put my Magic Keyboard vertically on a support but I could not find any model, this in order to make room on my desk to be able to use the most space to be able to work.
So I created my own support and I hope you like my work
Publish
I would be delighted if you took pictures of the impression of my work.
PRINT CONFIGURATION
I did a print test with a filling of 70% and it was good, but I advise you for an optimal result to make a filling of 90% or even 100%
For the layer height I advise you to make0.15mm but 0.20mm should be good too, it will depend on your desire to have a logo and smooth border or not
YOU ARE LOOKING FOR A MODEL WITH TWO LOCATIONS ?
You can find other version with two locations here
Changes
07/06/2020
Add logo on second walls
09/06/2020Center Logo
- Add version : Round edge 5mm
- Add version : Round edge 10mm
- Add version : Round edge 5mm with no wall edge rounds
- Add version : Round edge 10mm with no wall edge rounds
- Add version : Without any edge
Print Settings
Printer Brand: Prusa
Printer: I3 MK3S
Rafts: No
Supports: No
Resolution: 0.15
Infill: 70% or more