Simple Snowman Molds
We calculate the final price from your selected file. You review and accept it before payment.
Preliminary estimate for PETG
€2.81 – €3.43 net (excluding VAT)
For file: snowman mold 100mm 0.4n 0.2l_0.2mm_PETG_MK3S_3h20m.gcode
This is an estimate for one file. You’ll confirm the exact price before ordering.
File and estimate settings
File used for this estimate
Average indicative estimate: €3.12 excluding VAT (range midpoint).
- Weight reported by the author
- 37 g
- Print time reported by the author
- 3.34 hr
- Source material
- PET
- Estimate material
- PETG
- Estimate printer
- Bambu Lab P1S - 0.4 nozzle
- Estimate process
- 0.20mm Standard
Indicative estimate for the selected file only, based on the author’s weight and print time. File variants are not added together. The final price is calculated after file analysis.
Saved on this device.
100, 150 and 200mm sizes. Made to work with any type of snow. Prints without supports. Source files included!
- Rating
- 4 / 5
- Likes
- 49
- Downloads
- 167
- Makes
- 1
- Views
- 1,239
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Outdoor Toys
- License
- Open Community License v1.1 + General Attribution v1
Print twice for a complete mold. Larger nozzle sizes are strongly recommended for the bigger models. Best printed out of PETG, with 100% perimeters (instead of infill) and standing up straight with a large brim. Be mindful of the top of the head, due to the significant overhang.
I have printed mine with a 0.8n @ 0.55l.
For wet snow, fill both halves of the mold to the brim and press together. If you're working with powder snow, bury the molds in it and plow them through the snow towards each other several times, thoroughly compressing the snow inside the mold each time.
You can try rotating either half around its vertical axis by a few degrees to help unstick the snow from the mold or to remove any snow stuck between the edges. Slightly squeeze either half to demold the snowman.
If you're having trouble with snow sticking to the mold, try using silicone oil as a release agent.
You can get the model of the hat from here.