SD card holder for Prusa Bear mod
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
4 slot SD card holder for Prusa Bear
- Rating
- 0 / 5
- Likes
- 5
- Downloads
- 22
- Makes
- 0
- Views
- 150
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Accessories
- License
- Creative Commons — Attribution — Noncommercial
Print with the slot holes on the build plate for best results. If you print with the hole side down, there will be a very small gap between the build plate and the mounting tab, so I recommend using PETG. PLA may not stick on the tiny portion of the first layer, which will ruin the rest of the print.
This is a small print, but I recommend 80% infill and .20-.25mm layer height. The higher infill makes a nicer bottom surface. Remember that if you print it upside down, the bottom of the object will be on the top. Thinner layer heights work against you in this case and the print does not come out as clean.