Seigaiha Wave Bookmarks (Manual Filament Swap)
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A set of bookmarks featuring Seigaiha patterns, designed for multicolor printing with any FDM 3D printer.
- Rating
- 4.875 / 5
- Likes
- 257
- Downloads
- 656
- Makes
- 10
- Views
- 3,732
- Reviews
- 8
Updated at source:
Model information
- Source
- Printables
- Category
- Other Art & Designs
- License
- Creative Commons — Attribution — Noncommercial — NoDerivatives
A set of 15x4.5x0.1cm bookmarks featuring Seigaiha patterns, designed for multicolor printing with any FDM 3D printer.
These are very simple to print, just open them in your slicer of choice, and add layer stops where you want to swap filaments.
Bookmark 1 and 2 have a 0.4mm base, and the design is split between an initial 0.4mm layer and a top 0.2mm layer (1mm total height).
This means you can use 3 different filaments in the design, like I did in my white-black-copper and marble blue-white-transparent prints.
To get this result add a layer stop after 0.4mm, and a layer stop after 0.8mm.

Bookmark 3 and 4 have a 0.4mm base, and the design is split between 3 0.2mm layers (1mm total layer height).
This means you can use 4 different colors in the design, or use a light filament on top of a darker one to get a fade, like I did in my black-orange-copper, copper-white and black-white prints.
To get a fade between 2 colors just add a layer stop after 0.4mm. To use multiple colors in the design you can also add a layer stop after 0.6mm and/or 0.8mm.

These can be scaled freely, you can scale them on the X and Y axis to change their size, and scale them on the Z axis to change the thickness of the filament swap layers. Keep in mind you will need to do a bit of math to figure out where to put your layer stops, if you scale them on the Z axis.
You can find a list of filaments I used in the last picture.