Myford ML7 and Super 7 gear tray
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Tray to hold the gear wheels for the Myford ML7 and Super 7 lathes.
- Rating
- 5 / 5
- Likes
- 16
- Downloads
- 258
- Makes
- 2
- Views
- 1,508
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Tools
- License
- Creative Commons — Attribution — Noncommercial
Tray to hold the gear wheels for the Myford ML7 and Super 7 lathes. Designed for the standard set of 20 20 25 30 35 38 40 45 50 55 60 65 70 75
Print instructions
Category: Machine Tools Summary
Tray to hold the gear wheels for the Myford ML7 and Super 7 lathes. Designed for the standard set of 20 20 25 30 35 38 40 45 50 55 60 65 70 75
Print Settings
Printer Brand: FlashForge
Printer: Creator Pro
Rafts: Yes
Supports: Yes
Resolution: 0.2mm
Infill: 10%
Filament: 3dfilaprint PLA Silver
Notes:
I used a raft but it's not essential. There are four small cutouts to locate 20mm rubber feet, again you could probably get away without using any support material too.
Normally I use a wall thickness of 2 layers and floor/ceiling of 3, however this one is printed with a wall thickness of 3 for strength as the infill is only 10%. It's pretty solid.
How I Designed This
Drawn up on Fusion360, the gear tray has been designed to allow 40% engagement of the diameter of each gear. This felt like a good amount to secure the gear without using up too much material.
I did try optimising the design to shell from the bottom up to make the object hollow and use a lot less material. However, the savings did not come to fruition as the amount of support material was excessive.