Spare filter box for Respirator Mask "Brasil"
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
peter m’s face mask is so useable that I needed a box for carrying spare filters around in.
- Rating
- 0 / 5
- Likes
- 0
- Downloads
- 22
- Makes
- 0
- Views
- 326
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Home Medical Tools
- License
- Creative Commons — Public Domain
peter m’s face mask is so useable that I needed a box for carrying spare filters around in. There’s also a smaller compartment for a spare insert, adjusting clips, strap etc. The case and cap latch together, so it should be safe in a bag without spilling everything. Also included is a stencil for cutting out filters (embossed as such since some of my friends aren’t that smart, and you always forget what small unmarked pieces of plastic are actually for after a few months;-> For people with better memories, the STL file isn’t embossed.
The insert compartment is a tight fit so the actual insert stops any small clips falling out.
This works fine in PLA, but will probably last longer in PETG.
The whole lot takes about 6 & 3/4 hours to print using a 0.15mm layer; a single stencil is 20mins, the case 4 & 1/4 hours and the cap 2 hours if you print separately.
Layer height: 0.15
Infil: 15%
Shells: V 2, T 7, B 5
(I.e. Prusa Slicer defaults)
For speed over beauty I’d suggest a larger layer height.
Respirator Mask "Brasil”:
https://www.prusaprinters.org/prints/29745-respirator-mask-brasil-xs-s-m-l-xl