1 / 10
Sony FDR-X3000/X1000 helmet side mount — image 1
1 / 10

Sony FDR-X3000/X1000 helmet side mount

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Action camera helmet side holder I made this holder to be connected directly on helmet by 3M VHB tape or zip tie.

Rating
0 / 5
Likes
13
Downloads
123
Makes
0
Views
1,433
Reviews
0

Updated at source:

Model information

License
Creative Commons — Attribution

Action camera helmet side holder

I made this holder to be connected directly on helmet by 3M VHB tape or zip tie. However zip ties requires to makes holes into helmet, which is not recommended way (keep on mind that any modification of your helmet means void of its warranty and have negative impact on helmets protection ability!).

Holder consists of 2 parts so it can be folded when it is not used. Camera is connected over 1/4 stativ screw. Theoretically there can be connected any of FDR Sony action cams, but personally I tested only FDR-X3000 and FDR-X1000.

Just note that the nice helmet in model made by Ivan Spasić was loaded from here.

Additional parts:

  • Screw ISO4017 - M5x40
  • Nut ISO4032 - M5
  • 1/4 stativ screw (e.g GITZO D116.138)
    ### Changelog:

*25.11.2018

After years of using I found that even smaller holder would be better ;-).


*7.1.2017

After day on snow in mountains I found that stativ screw wrapped by ice made impossible to remove camera from helmet till ice is melt. Therefore I modified screw head. Groves on the side of head was replaced by smooth surface to prevent from locking by ice.


*8.12.2016
Created first model of holder. Model was successfully tested at home.

Print instructions

Category: Camera Summary

Action camera helmet side holder

I made this holder to be connected directly on helmet by 3M VHB tape or zip tie. However zip ties requires to makes holes into helmet, which is not recommended way (keep on mind that any modification of your helmet means void of its warranty and have negative impact on helmets protection ability!).

Holder consists of 2 parts so it can be folded when it is not used. Camera is connected over 1/4 stativ screw. Theoretically there can be connected any of FDR Sony action cams, but personally I tested only FDR-X3000 and FDR-X1000.

Just note that the nice helmet in model made by Ivan Spasić was loaded from here.

Additional parts:

  • Screw ISO4017 - M5x40
  • Nut ISO4032 - M5
  • 1/4 stativ screw (e.g GITZO D116.138)
    ### Changelog:

*25.11.2018

After years of using I found that even smaller holder would be better ;-).


*7.1.2017

After day on snow in mountains I found that stativ screw wrapped by ice made impossible to remove camera from helmet till ice is melt. Therefore I modified screw head. Groves on the side of head was replaced by smooth surface to prevent from locking by ice.


*8.12.2016
Created first model of holder. Model was successfully tested at home.

Print Settings

Printer: Rebel II

Rafts: Doesn't Matter

Supports: No

Resolution: 0,4 mm

Infill: 100%

Notes:

ABS

Tags