Precision Screwdriver Stand

I have a set of precision screwdrivers that I've been keep in a drawer. The issue is that I'm always using them, so they usually stay out on my workbench rather than getting put back up. This stand was my solution to keep them out on the bench and in reach while still keeping things organized.

The holes are sized for 15mm, so as long as your screwdrivers have a thicker section in the handle it should work. I may redesign it so that the angle on the main plate is steeper, but I haven't tested it to make sure it will print. I've added the link below to the design on OnShape. It is parametric, so you can change the radius parameter to the thickness you need. Also there is a offset variable that will allow you to alter the spacing. You can find the design at https://cad.onshape.com/documents/1e65396c485b81b9b5f4644b/w/3cff9924f445dff40c7f5335/e/29da03a7d37f126b6be74564?renderMode=0&uiState=63af4719dfe2187a3bcd8971.

I'd suggest printing it with a 0.2mm layer height and 15% infill. It should print without any supports if you place the part with the holes face down on the bed.