Case for W1209 Temperature Control Switch
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Needed a case for my temperature control switch (12V) W1209. W1209 are available in 5, 12, 24V (maybe more). In my…
- Rating
- 5 / 5
- Likes
- 20
- Downloads
- 380
- Makes
- 2
- Views
- 1,439
- Reviews
- 2
Updated at source:
Model information
- Source
- Printables
- Category
- Other Ideas
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
Needed a case for my temperature control switch (12V) W1209.
W1209 are available in 5, 12, 24V (maybe more). In my case I used one common 12VDC source and connected the relay contacts to switch my (noisy) cooling fan on and off.
Pretty simple.
Tip: I used four M3 "Brass Heat Set Inserts" but only used two screws in the rear. The front screws are too high for the lid. So you may save two brass inserts.
Print Settings
Printer:
Voron 0.1
Rafts:
Doesn't Matter
Supports:
Yes
Resolution:
0.2mm
Infill:
15%
Filament:
Doesn't matter PLA
Doesnt matter
Notes:
I printed the lid on the side, therefore, with raft and supports.
Category: Hobby