Nespresso dual stacked pod holder

Designed from scratch to hold a pair of Nespresso coffee pod tubes.
The goal was to take up less countertop space than the single stacked designs. 

There are spaces for the labels cut from the box lid to be placed. 

Designed not to latch together, so the sides stay looking clean, and makes them easier to refill / replace the tube. 

• print 3 pins per left/right.
• pins have two flat sides, to allow them to be printed on the side, to keep the layer lines in the stronger orientation for this print. 

I print the pins at a smaller layer height than the sides, but can fit both sides on the bed of a mk3.

optionally can glue the sides together with CA glue as well. 

Printed with PLA with a 0.6mm Nozzle.