anet a8 larger Y axis motor mount
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Swapped the factory board for an skr e3 v2, factory motor keeps getting too hot, even at 50 milliamps. I have tried…
- Rating
- 0 / 5
- Likes
- 1
- Downloads
- 20
- Makes
- 0
- Views
- 229
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other Printer Parts & Upgrades
- License
- Creative Commons — Attribution
Swapped the factory board for an skr e3 v2, factory motor keeps getting too hot, even at 50 milliamps. I have tried everything I can think of to get the motor to operate at normal temperature (switched polarity around, lowered current in firmware, 50/50 square wave... I've tried many different groups of configurations but can't seem to pinpoint the issue. All the other motors are working correctly. The motor in this setup is a stepperonline nema 17 1.5a from amazon, only running it at 530ma, still quite warm to the touch but not nearly as bad.
Version 2- The m3 nuts slot in from the bottom and replace the motor support bracket, you will need longer screws than stock
*edit*
Issue has been resolved, noob mistake. If you are experiencing a similar issue then please check this bug report: https://github.com/MarlinFirmware/Marlin/issues/19037
Category: 3D Printer Parts