beagle camera arm
We calculate the final price from your selected file. You review and accept it before payment.
Estimated printing price per file
€4.28 – €5.24 net (excluding VAT)
For file: beagle camera arm base parts_0.2mm_PLA_MINI_5h10m.gcode
This is an estimate for one file. You’ll confirm the exact price before ordering.
File and estimate settings
File used for this estimate
Average indicative estimate: €4.76 excluding VAT (range midpoint).
- Weight reported by the author
- 51 g
- Print time reported by the author
- 5.17 hr
- Source material
- PLA
- Estimate material
- PLA
- Estimate printer
- Bambu Lab P1S - 0.4 nozzle
- Estimate process
- 0.20mm Standard
Indicative estimate for the selected file only, based on the author’s weight and print time. File variants are not added together. The final price is calculated after file analysis.
Saved on this device.
modular print camera arm mounted on 30x30 alu. profile no t-nuts needed, vertical or horizontal mount
- Rating
- 0 / 5
- Likes
- 14
- Downloads
- 48
- Makes
- 0
- Views
- 937
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Accessories
- License
- Creative Commons — Attribution — Noncommercial
can be mounted high or low on vertical or horizontal on 3030 aluminium profile with no t-nuts.
base is 2 parts, put 1x m5 nut (6k 8x4mm, DIN 934) and use e m5x14 to tight base 1 when its in place in profile (designed with 2 screws but established that one was enough to hold it)
for the camera mount you need end, end 2, and 2x end 3. if holes for the taps is to tight you might have to gentle drill them out little with 5mm drill and the tighten it up with m5x35 and m5 nut
and between them you can compose arm configuration you need for your camera, for tightening use M6x35 and M6x40 and m6 nuts with 10mm key width and if you want it tool free print some M6 wing screws
and there is a universal mount to with 6,2mm hole to screw some other fastener on it