3x3 Calibration Grid - Prusa Mk2.5/Mk3
We calculate the final price from your selected file. You review and accept it before payment.
Estimated printing price per file
€0.13 – €0.16 net (excluding VAT)
For file: calibration-grid_02mm_pla_mk3.gcode
This is an estimate for one file. You’ll confirm the exact price before ordering.
File and estimate settings
File used for this estimate
Average indicative estimate: €0.15 excluding VAT (range midpoint).
- Weight reported by the author
- 1 g
- Print time reported by the author
- 11.4 min
- Source material
- PLA
- Estimate material
- PLA
- Estimate printer
- Bambu Lab P1S - 0.4 nozzle
- Estimate process
- 0.20mm Standard
Indicative estimate for the selected file only, based on the author’s weight and print time. File variants are not added together. The final price is calculated after file analysis.
Saved on this device.
Use this Grid to help optimize first-layer adhesion.
- Rating
- 5 / 5
- Likes
- 18
- Downloads
- 349
- Makes
- 1
- Views
- 1,403
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Test Models
- License
- BSD License
Use this Grid to help optimize first-layer adhesion. G-code file includes a warmup routine to improve accuracy of bed-leveling. The print will appear to do nothing for a minute or two as the PINDA probe warms up via close proximity to the heat bed. If printing fails to begin, ambient air temperature is too cold/drafty. Try insulating the PINDA from drafts with a folded sheet of paper or aluminum foil. Once printing begins, remove the insulation.
Let the print bed cool off, then gently lift the print at one corner and peel the whole print off.
Examine the underside of each square patch and observe differences in how closely squished the plastic lines are. Can you see daylight through the print? You shouldn't see much - maybe a tiny sliver here and there. And each square patch should have a similar texture. Measure the thickness of each patch to understand how accurate bed leveling is at each corner. Adjust the mechanicals or calibration parameters of your printer until all patches measure the same and have similar textures on the bottom.