1 / 3
Door Bumper for Land Rover
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Door bumper that fits Land Rover LR2 (AKA Freelander 2). This will likely fit many other models as well.
- Rating
- 0 / 5
- Likes
- 8
- Downloads
- 35
- Makes
- 0
- Views
- 536
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Automotive
- License
- Creative Commons — Attribution
I was missing one of my door bumpers, so I created a new one with some improvements to keep it from falling out.
Printing Tips
- Use flexible like TPU or TPE (I used TPE)
- Print at 10% infill
- Use cubic infill pattern (this had more flex over grid)
- Make sure retraction speed is low (i.e. 20mm/s)
Installation Tips
- Squeeze where indicated in the diagram below
- Push tip into hole in door at a slight angle and twist while holding pressure on the bumper
The bumper should work its way into the hole. I found if I printed this at too high on an infill percentage, the bumper was impossible to insert into the door, because it was too stiff.