Japanese Torii Gate
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
I designed a 4 part Japanese Torii gate 3 pre-generated sizes uploaded
- Rating
- 4.5 / 5
- Likes
- 93
- Downloads
- 804
- Makes
- 5
- Views
- 3,488
- Reviews
- 4
Updated at source:
Model information
- Source
- Printables
- Category
- Home Decor
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
A 4-part Japanese Torii gate
General:
0,2mm layer height
Printer using PLA
Black and Red colour
Sizes:
3 pre-generated sized available to download. Main dimensions table below:
| Height [mm] | Width[mm] | |
| Small | 73 | 110 |
| Medium | 117 | 177 |
| Large | 161 | 243 |
Printing:
The black parts (Feet and top beam) are fairly simple to print.
The red part (main body) might be a little tricky. The way I managed to do it is shown below:
I printed it upside down with supports enabled.
I added 4 manual supports tapered wider at the base (to prevent it falling over)
I added a 5mm wide brim for further support
This way I managed to print it without falling over.
Removing the supports does take some time. Cutting it away piece by piece I was able to remove it.
Assemble:
Push the feet over the legs of the torii gate main body
The vertical beams are not at a perfect 90degree angle. So rotate the feet accordingly so they are flush with the surface below.
Place the Top beam on top of the main body
I did use some glue to attach them together. But it can do without