Autotrickler Autothrower straw replacement
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
This 3d printed cone replaces the autotrickler straw, which was always a pain for me. I never found a perfectly…
- Rating
- 0 / 5
- Likes
- 1
- Downloads
- 44
- Makes
- 0
- Views
- 436
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other Ideas
- License
- Creative Commons — Attribution
This 3d printed cone replaces the autotrickler straw, which was always a pain for me. I never found a perfectly matching straw (and I tried a lot, big M, sbwy, some from the shop, etc) and there was a lot of powder spillage due to the falling height of the powder. This uses the bayonet lock library and basically puts a hull around two cylinders in openscad to get a cone with offset. It's two parts, one attaches directly to the Autotrickler.com A&D FX120i mount. The funnel then locks onto that via bajonet. The Bayonet Lock Connector is from the OpenSCAD library (http://www.thingiverse.com/thing:3471896) by xavierasx, licensed under the Creative Commons - Attribution license. http://creativecommons.org/licenses/by/3.0/
If the bajonet lock is too tight on your printer, increase the "gap" value in the openscad file.
Just added a new version, improvements:
- bigger screw holes, they were too small
- countersunk screw holes
Print Settings
Printer Brand:
Prusa
Printer:
i3 MK2.5
Rafts:
No
Supports:
No
Filament: FilamentPM PETG
Category: Parts