Holder for Dog Leashes/Long Lines
We calculate the final price from your selected file. You review and accept it before payment.
Preliminary estimate for PETG
€2.79 – €3.41 net (excluding VAT)
For file: leash-holder-small_03mm_petg_mk3s_2h52m.gcode
This is an estimate for one file. You’ll confirm the exact price before ordering.
File and estimate settings
File used for this estimate
Average indicative estimate: €3.10 excluding VAT (range midpoint).
- Weight reported by the author
- 47 g
- Print time reported by the author
- 2.86 hr
- Source material
- PET
- Estimate material
- PETG
- Estimate printer
- Bambu Lab P1S - 0.4 nozzle
- Estimate process
- 0.20mm Standard
Indicative estimate for the selected file only, based on the author’s weight and print time. File variants are not added together. The final price is calculated after file analysis.
Saved on this device.
Organize your dog leashes!
- Rating
- 5 / 5
- Likes
- 181
- Downloads
- 592
- Makes
- 8
- Views
- 2,409
- Reviews
- 6
Updated at source:
Model information
- Source
- Printables
- Category
- Pets
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
I train dogs for canine nose work and retriever field work, and have a collection of long lines and leashes of various length. For a while I have tried to find a way to organize them a bit better than just throwing them all in a bag -- and untangling them later. None of the designs I came up with worked too well. Then one day I was in the garage grabbing an extension cord and noticed the holder it was on. "Huh", I thought, "this might just work". So I fired up Fusion and a few hours later I had this design, which is derived from the extension cord holder but adds a couple of specific features.
Most of my lines have a knot at the end, which goes into the slotted end. Then I wrap the line around the main body of the holder and finally secure the clip in one of the many holes around the edges. With many holes, it should be easy to find one that works for the length of your line. For leashes with a handle, I just put it around one of the protruding "horns".
I made the leash holder in two sizes. The small one is about 8 x 4.25 in (20 x 11 cm) and is fine for lines shorter than 10 or 12 feet. The larger one is for longer lines and is about 9.25 x 4.25 in (23.5 x 11 cm).
Print instructions
Resolution: 0.3
Infill: 20%
If you want to keep in a car or outside where temperatures can get high, use PETG or ABS/ASA.
Supports are only needed for the slotted ends. In PrusaSlicer or Cura I use support enforcers/custom supports in those areas.
If you like what I'm doing…
… consider buying me a coffee or joining my Club.