MK3S/S+ Bed Y-Tilt-Compensator-for-Z-Axis
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
MK3S/S+ Bed_Y-Tilt Compensator-for-Z-Axis
- Rating
- 0 / 5
- Likes
- 2
- Downloads
- 21
- Makes
- 0
- Views
- 371
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Prusa Parts & Upgrades
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
Bed_Y-Tilt Compensator for Z-Axis for MK3S/S+
I made this because my bed had an inherent tilt around the Y axis and even with my bed leveling in place I wanted something to correct it.
The Z calibration upper reference points are the x-ends and the caps of the screws used to mount the z-axis brackets to the frame.
Using the thumb screw you can transfer the reference to one of the screw holding the spline nut and the thumb screw, and use them to equalize the Z travel on each side.
Installing these brackets will also allow reverting to the original references by driving back the thumb screws.