1 / 2
Portable Airplay Speaker
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
This is an ok sounding portable Airplay speaker.
- Rating
- 0 / 5
- Likes
- 32
- Downloads
- 252
- Makes
- 0
- Views
- 2,165
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Audio
- License
- Creative Commons — Attribution — Noncommercial
This is an ok sounding portable Airplay speaker.
Print instructions
I printed this at 0.3 layer height with no supports because I'm impatient and I knew I was going to paint it.
The USB C charger board is a real tight fit, once your satisfied superglue along the board edge. I kept all the wires short and hot glued everything to the rear panel. you can see the red light glow through the port while its charging.
Install Raspberry Pi OS lite, setup the Adafruit Speaker Bonnet per their instructions, finally use apt to install shairport-sync.
- Switch - https://amzn.com/B01N2U8PK0
- USB C LiPo Charge Controller - https://amzn.com/B07PKND8KG
- 3” Speakers - https://amzn.com/B00K2ESJZ2
- Adafruit Speaker Bonnet - https://amzn.com/B01MXYBVKZ
- 2A Adjustable Step-Up Boost Converter - https://amzn.com/B07VKSMC5T
- Raspberry Pi Zero W
- Single LiPo Cell ( I Used a 4000mAh 21700 )