1 / 7
ZeroG ABS/ASA Callibration Print
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A test print to evaluate ABS/ASA shrinkage and check hole sizes before actual printing.
- Rating
- 4.905 / 5
- Likes
- 206
- Downloads
- 2,641
- Makes
- 27
- Views
- 8,954
- Reviews
- 21
Updated at source:
Model information
- Source
- Printables
- Category
- Test Models
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
We've created a test print to calibrate your settings printing in ABS/ASA.
The test print contains
- 5mm Dowel pin hole top to bottom
- This is a 5.3mm hole to compensate for shrinkage
- 5mm Dowel pin hole side to side
- This is a 5.3mm hole to compensate for shrinkage
- M3 Hole including a heatset insert (M3 X D5.0 X L4.0)
- M3 through hole
- This is a 3.3mm hole to compensate for shrinkage
- 0.4mm Single wall to verify .4 print settings
- Overhang / bridge test in the bottom
- Overhang test up to 70°
- X and Y lettering to check for ringing.
To test this print you need to use the following settings
- First layer 0.25mm
- Other layers 0.2mm
- Wall thickness 0.4mm
- Walls - Up to you
- Top / Bottom - Up to you
- Infill - Up to you
Recommended filament
- ABS