Rubber band loaded Business Card Holder / Dispenser
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A rubber band spring loaded Business Card Holder!
- Rating
- 4 / 5
- Likes
- 57
- Downloads
- 265
- Makes
- 1
- Views
- 2,469
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Organizers
- License
- GNU General Public License v3.0
Description
Rubber band loaded Business Card DISPENSER
This is a dispenser of Business Cards which used rubber bands for a “spring-loaded” mechanism.
The main idea got from Honza, so go visit his profile to see his other designs. Honza | Printables.com
Materials you will need.
- 2 Rubber band of Ø56mm OR 4 Rubber band of Ø22mm
- Business cards approximate measurement of 76.2 mm of length and 50.8mm of width or 2"x3.5" (See picture below)
Print Orientation and Notes

![]() | 1-Main Body, support will only be needed in the middle of the entrance of the wipes.
|
![]() | 2-Riser
|
![]() | 3-Hook
|
![]() | 4-Press-Fit Screw
Need to print 4 of them |
For material, PLA or PETG works great with this design.
Assembly


Section View
You will need some patience for this step.
If you are going to used 2 large rubber bands, you should fold it in 2 and place it as shown in the figure on the right. (This is more difficult)
If you are going to use 4 small rubberbands, you should put them double in each length to have greater strength.
It is extremely important that the elastic bands are inside the channel of the 2-Riser. The photo below shows how it should look. if this is not done, the mechanism may get stuck or jam.

HAPPY PRINTING! :)



