Shower Curtain Hook Bracket for Existing Shower Door Rails

We have an old bathroom in our house and the sliding glass shower doors needed to be removed, however the rail support system was intact and we did not wish to remove it. Until we figure out what to do overall we wanted to hang a shower curtain but did not want to modify the area for a typical rod. Using ACE hardware shower rings and a standard shower curtain we designed a bracket to fit inside the door rail system that allows for the curtain to slide freely and maximize the shower entry without the annoying rod. 

The bracket was printed on a Prusa MK2S with Hatchbox White PLA. Bed temp was maintained at 60 degrees C. First Layer was produced with 215 degree C hotend temp with all other layers at 210 degrees C. Infill rate for prints was 30% and speed was set to Normal. Print time was roughly 28 minutes at these settings. No supports or rafts are required in the orientation in the files. CAD was produced on Fusion 360 Non Commercial License. Anyone using these files for commercial gain does so at their own risk. All files have been included including F360, PDF dimensioned drawing, .stl and gcode sliced on Prusa slicer.