Airsoft keymod rail 35mm
We calculate the final price from your selected file. You review and accept it before payment.
Estimated printing price per file
€0.35 – €0.43 net (excluding VAT)
For file: RIS Keymod 35 mm simple_0.2mm_PLA_MK3S_26m.gcode
This is an estimate for one file. You’ll confirm the exact price before ordering.
File and estimate settings
File used for this estimate
Average indicative estimate: €0.39 excluding VAT (range midpoint).
- Weight reported by the author
- 4 g
- Print time reported by the author
- 25.8 min
- Source material
- PLA
- Estimate material
- PLA
- Estimate printer
- Bambu Lab P1S - 0.4 nozzle
- Estimate process
- 0.20mm Standard
Indicative estimate for the selected file only, based on the author’s weight and print time. File variants are not added together. The final price is calculated after file analysis.
Saved on this device.
35mm keymod rail for airsoft guns.
- Rating
- 5 / 5
- Likes
- 72
- Downloads
- 260
- Makes
- 4
- Views
- 1,032
- Reviews
- 3
Updated at source:
Model information
- Source
- Printables
- Category
- Outdoor Sports
- License
- Open Community License v1
I created this because I know that this is a part that I will need in the future for my airsoft attachments.
Print it with 0.2mm layer height, 10mm brim and supports enabled. Print this from the side that is touching the gun when attached otherwise the top surface will have very bad quality and you might have problems attaching accesories to it.
I will make various lengths in the future and i also plan to make that small keymod part that locks it in place. Obviously these parts are best made from aluminum but maybe platic will work as well.
10/03/2023 - I have added a simple version to make printing it a lot easier, the only disadvantage of the simple version is that the on the normal version there are these “guides” at the bottom which make attaching it to the weapon easier. When i was looking back at the old gcode i have also realized that you don't even need to use supports for the hole, you can use sacrificial bridging instead. I have changed that in the new gcode that i added as well. All you have to do after printing is just cut out the small pieces of filament inside the hole.