1 / 1
IKEA SKADIS - spray can holder / držák sprejů — image 1

IKEA SKADIS - spray can holder / držák sprejů

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Spray can holder for IKEA SKADIS board - fits most typical cans with ca 66 mm diameter, tight fit into the board,…

Rating
4.8 / 5
Likes
226
Downloads
1,272
Makes
29
Views
3,254
Reviews
30

Updated at source:

Model information

Category
Organizers
License
Creative Commons — Attribution

Spray can holder for IKEA SKADIS board - fits most typical cans with ca 66 mm diameter, tight fit into the board, slightly reinforced

Držák sprejů pro IKEA SKADIS desku - pasují do něj nejběžnější plechovky s průměrem 66mm

Print instructions

Any material is suitable - but best would be PETG or PLA (for indoor use)
Basic print settings are OK, preferred 0.2 - 0.25 layer height, 0.4 nozzle. If You want the part to be stronger, change perimeters to 3 and both top and bottom layers to 5. Infill is enough around 15%
FreeCAD model included for adjustments if needed.

Lze použít jakýkoli materiál, ale nejlepší bude PETG nebo PLA (při použití v interiéru)
Základní nastavení tisku bohatě stačí, doporučuji 0.2-0.25 mm vrstvu, 0.4mm trysku. Pokud chcete aby byl držák trochu robustnější, nastavte 3 perimetry a 5 spodních a vrchních vrstev. Infill stačí kolem 15%
Přiložen i FreeCAD model pro případné změny v designu.

Tags