1 / 1
KP3S Y-Belt Tensioner M3 Nylock Remix — image 1

KP3S Y-Belt Tensioner M3 Nylock Remix

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

KP3S Y-Belt Tensioner remixed to utilize a M3 Nylock instead of a captive square one.

Rating
0 / 5
Likes
3
Downloads
59
Makes
0
Views
324
Reviews
0

Updated at source:

Model information

License
Creative Commons — Attribution — Noncommercial

I liked this design and it adds a QOL life to an already robust and capable printer.

However when testing the original design I found that the square nut wiggled too much for my liking and I worried that vibrations would cause the tensioning system to undo itself overtime. Also, after dealing with the effects of a MK3S with a nylock that bounced in and out of its cavity, I didn't want my KP3S to suffer the same fate. 

This remix allows you to secure a M3 Nylock instead. I haven't tested tolerances but it should be a tight fit. Remember when installing use a m3 screw to pull the nut into the cavity.

You will probably want a longer screw, the stock m3x16 one should work just fine.

Prints without support, use PETG ideally or ABS/ASA if you can swing it.

0.2mm layer height, 3-5 walls, 4-5 top/bottom layers, and 20-25% gyroid infill should be plenty for this part.