Tetrabolo Puzzle
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Geometric tiling puzzle with 14 tetrabolo pieces and a storage box with a sliding lid.
- Rating
- 0 / 5
- Likes
- 10
- Downloads
- 65
- Makes
- 0
- Views
- 377
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Puzzles & Brain-teasers
- License
- Creative Commons — Attribution — Noncommercial — NoDerivatives
🧩 Tetrabolo Puzzle
Each puzzle piece consists of four right-angled isosceles triangles. The puzzle pieces can be used on either side. You can also use them to create many other shapes.
🖨 Print Settings
Material: PLA · No supports · No raft or brim
You can print the snap-fit lid with either side on the print bed. For a nicer finish on the visible surface, place the top side face down.
You can ignore the slicer warning caused by the breakaway connection of the spring tabs underneath the lid.
🔧 Before Using the Lid for the First Time
Release both spring tabs before sliding the lid into the box. Otherwise, the lid may get stuck and become very difficult to remove.
Press the two spring tabs underneath the lid inward, one at a time, to release them. You should hear a small snap.
If a spring tab is difficult to release: Place a hard board on the table. Hold the lid on its edge and press the spring tab against the board to release it. Repeat for the other spring tab if needed.
The animation in the image gallery shows how to release the spring tabs.
💡 Tip for Better-Looking Puzzle Pieces
For a consistent finish on both sides, print two sets at half thickness. To do this, lower the pieces 2.0 mm into the build plate in your slicer, mirror one set, and glue the matching halves together.
🌐 More Polyform Puzzles and Background Information
🧩 More Polyform Puzzles on Printables
⚠ Safety Note
Choking hazard due to small parts. Not for children under 3 years.