Simple Sanding Block
We calculate the final price from your selected file. You review and accept it before payment.
Preliminary estimate for PETG
€3.58 – €4.38 net (excluding VAT)
For file: simplesandingblock_025mm_petg_mk3s_3h57m.gcode
This is an estimate for one file. You’ll confirm the exact price before ordering.
File and estimate settings
File used for this estimate
Average indicative estimate: €3.98 excluding VAT (range midpoint).
- Weight reported by the author
- 54 g
- Print time reported by the author
- 3.95 hr
- Source material
- PET
- Estimate material
- PETG
- Estimate printer
- Bambu Lab P1S - 0.4 nozzle
- Estimate process
- 0.20mm Standard
Indicative estimate for the selected file only, based on the author’s weight and print time. File variants are not added together. The final price is calculated after file analysis.
Saved on this device.
Sanding block with simple construction. Made to work with a 38mm x 230mm - 240mm sandpaper stripe.
- Rating
- 4.95 / 5
- Likes
- 843
- Downloads
- 5,154
- Makes
- 112
- Views
- 16,463
- Reviews
- 100
Updated at source:
Model information
- Source
- Printables
- Category
- Tools
- License
- BSD License
Sanding block with simple construction. Made to work with a 38mm x 230mm - 240mm sandpaper stripe.
After trying out a few sanding blocks, not finding anything fitting my needs. Either they were over-complicated, screws were fiddly, the tolerances were off, or they just broke to easy.
I wanted a simple sanding block that could clamp the sanding paper in place when sanding and not break so easily.
So I made my own with a beefy bolt, M22 (3mm pitch) threads with adjusted tolerance for 3D printing. This large bolt is easy to adjust and pretty durable.
There is so much friction in sanding paper so a simple clamping construction is enough to hold it in place.
I use this block to sand 3D prints in PET-G with wet sandpaper.
Print instructions
.gcode has a layer height of 0.25 with 4 perimeters for strength. The infill is set to 15% with a rectilinear pattern.
A complete sanding block consists of:
- 1x base.stl
- 1x clamp.stl
- 1x bolt.stl
Only did this in PET-G but should work very well (maybe even better) in PLA.