1 / 3
Encoder knob
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Little knob meant for a rotary encoder and mainly for the Pikatea R26
- Rating
- 5 / 5
- Likes
- 22
- Downloads
- 325
- Makes
- 2
- Views
- 1,535
- Reviews
- 2
Updated at source:
Model information
- Source
- Printables
- Category
- Computers
- License
- Creative Commons — Attribution — Noncommercial
Needed a small encoder knob to fit the Pikatea R26. I didn't have set screws to use the original knob from Pikatea, so I made this one to fit snugly around the shaft of the encoder.
Made to fit rotary encoders with a flat side on the shaft, like these : here
Print instructions :
Print with the hole facing the build plate.
Layer height : 0.2 mm
Perimeters : 3
Bottom and top layer : 3
Infill : 10 - 15% (as you wish)
Support : yes (used it inside to have no drooping inside the hole)