1 / 9
Planter 19 - Lift Me Up, with holder — image 1
1 / 9

Planter 19 - Lift Me Up, with holder

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

The perfect happy place for your succulents, cactus, etc.

Rating
0 / 5
Likes
171
Downloads
399
Makes
0
Views
1,774
Reviews
0

Updated at source:

Model information

Category
Home Decor
License
Creative Commons — Attribution — Noncommercial — NoDerivatives

https://www.buymeacoffee.com/maxt

----------------------

I suggest adding some felt pads to the bottom of the feet to minimize the probability of scratching your table.
 

SETTINGS / PRINTING (recommendation)

Filament: PETG or PLA. Please note that PLA can deform/break down in the sunlight. In addition, some types of PLA are biodegradable.
Print: 0.2mm
Nozzle: 0.4mm

Support, planter: Not required, print 1x on the bottom
Support, holder: Not required, print 2x on the side
Support, leg: It all depends on your printer. It's not required on mine. But you might want to enable it as it will require under 1gr of support for all 4 legs, so why risk it? Print 4x standing up (vertical)

Brim, planter: Not required
Brim, holder: Not required
Brim, leg: Required, 3-5mm

Infill: 15-25%
Perimeters: at least 2, best 3 (minimizing probability of holes and water damage to your table)
Vase mode: No. While it is tempting to 3D print planters in the Vase mode, I find that there is just not enough fusion between the layers. In addition, a few micro-holes may appear during the sanding/handling of the finished planter. The water will find its way, even through a rock, so there's no reason to risk it.

OTHER

- If you are really worried that the planter might leak, use a waterproof sealant spray (for example Rust-Oleum Crystal Clear) inside of the planter, 3-4 coatings should be enough.
You could also read the official Prusa blog post “Watertight 3D printing PT1: Vases, cups and other open models”.

- To make the planter smooth and shiny, you could use sandpaper, prime it, (spray)paint it a couple of times and use a varnish coat on top.

 

Happy Printing!

--------------

https://www.buymeacoffee.com/maxt

Tags