1 / 3
Lolin 2.4" Display Case and Stand
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A case and stand for the Lolin 2.4" display using an ESP32 running OpenHASP
- Rating
- 0 / 5
- Likes
- 8
- Downloads
- 74
- Makes
- 0
- Views
- 555
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Electronics
- License
- Creative Commons — Attribution
Supports are only needed on the Case Back where it mounts to the base is located.
I used the support enforcer to create supports for only that face from the build plate.
Currently the M2 screws thread directly into the front case. I plan to add a front that allows for heat set inserts once I get some better ones in shortly.
Other needed parts:
- 4x M2x16mm with flat countersunk heads - for the display enclosure
- 1x M3x16 with socket heads - for mounting the display enclosure to the base
- 1x M3 hex nut - 5.4mm from each face of the nut
- 1x Lolin TFT 2.4"
- 1x TTGO T7 V1.5 MINI32 ESP32
Software and Hardware links for OpenHasp can be found through the link below:
https://www.openhasp.com/0.6.3/getting-started/#recommended-boards