Hero Session 5 SourceOne (v3) Camera Butter
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Remixed this. Few changes: 1) added about .75 mil of height. The original is a tight fit and holds with friction,…
- Rating
- 0 / 5
- Likes
- 3
- Downloads
- 20
- Makes
- 0
- Views
- 123
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- RC & Robotics
- License
- Creative Commons — Attribution
Remixed this. Few changes:
added about .75 mil of height. The original is a tight fit and holds with friction, problem is it stretches a tad and the vertical bars on the face "warp" inwards. Not a big deal, it just bothered me.
pulled face forward about 1.75mm (after the drop down) to make room for a camera butter ND stick on filter.
Point two caused the corners of the mount to show in a superview frame, so I cut out the corners.
points one and 2 made the session fit a little too losely for my likeing and it was no longer a trustworthy friction fit. Added a slip on band to help hold it all together. You can always use a rubber band, but, meh.
point 4 added about 1.5g, so I cut a square out of the back to reduce weight.
Print Settings
Printer Brand:
Creality
Printer:
Ender 3 Pro
Rafts:
No
Supports:
Yes
Resolution:
0.16
Infill:
40
Filament: SainSmart TPU Why
Notes:
weighs under 12g with sainsmart tpu at 40% gyroid infill in cura.
Category: R/C Vehicles