Pig - Version1 - plain
We calculate the final price from your selected file. You review and accept it before payment.
Estimated printing price per file
€1.79 – €2.19 net (excluding VAT)
For file: pig_50percent-tilted02mm_pla_mk3s_2h25m.gcode
This is an estimate for one file. You’ll confirm the exact price before ordering.
File and estimate settings
File used for this estimate
Average indicative estimate: €1.99 excluding VAT (range midpoint).
- Weight reported by the author
- 16 g
- Print time reported by the author
- 2.42 hr
- Source material
- PLA
- Estimate material
- PLA
- Estimate printer
- Bambu Lab P1S - 0.4 nozzle
- Estimate process
- 0.20mm Standard
Indicative estimate for the selected file only, based on the author’s weight and print time. File variants are not added together. The final price is calculated after file analysis.
Saved on this device.
This is Version 1 of four pig prints as follows: V1 : plain pig V2 : piggy bank #1 with slot only V3 : piggy bank #2…
- Rating
- 5 / 5
- Likes
- 6
- Downloads
- 88
- Makes
- 3
- Views
- 453
- Reviews
- 2
Updated at source:
Model information
- Source
- Printables
- Category
- Sculptures
- License
- Creative Commons — Public Domain
This is Version 1 of four pig prints as follows:
- V1 : plain pig
- V2 : piggy bank #1 with slot only
- V3 : piggy bank #2 with slot and bottom opening
- V4 : Matryoshka pig(s)
All versions use the same basic design, with some significant variations. Since there are so many different prints involved, with differing print requirements I thought it best to provide the prints as four separate entries.
Initially I started with the idea of just seeing if I could create a pig sculpture in OnShape 3D CAD, but with the idea that if I was successful I could create the different versions as well.
The OnShape 3D CAD files for this are here:
Print instructions
Print in PLA using the 3mf file provided. Note that the included print files are for a print scaled down to 50%. I did not attempt to print a full size print of this version.
Otherwise:
Print tilted as shown in the photos,
- infill = 0%
- perimeters = 3
Additional information:
When I attempted a print "feet down" I ended up with a hole in the top of the back.
When I attempted a print "nose down" I ended up with a hole at the tail end.