Felt Mat Corner Holder
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Holds a 3.5mm to 4mm thick felt mat, like those sold by Grovemade.
- Rating
- 0 / 5
- Likes
- 2
- Downloads
- 21
- Makes
- 0
- Views
- 353
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Office
- License
- Creative Commons — Attribution — Noncommercial
Holds a 3.5mm to 4mm thick felt mat, like those sold by Grovemade.
Designed specifically for 3M Command Strips to hold in place, one strip will handle two of these corners (I only needed two to hold the back of my mat in place as it always slid back).
You can make your own for different thicknesses by remixing my OnShape (linked).
Print instructions
You can probably print this 0.2mm no problem, but 0.10mm with supports everywhere is what I did because I liked the smoother finish more. Post-processing isn't too hard but takes a few minutes and an xacto knife.
Flip the print so the 3M indent is upward, and consider the angle of the first layer infill when rotating on the print bed–to taste.