Cake Decorating Spinning Stand
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Variations of a spinning cake stand. Helpful for decorating cakes, or displaying items!
- Rating
- 5 / 5
- Likes
- 36
- Downloads
- 126
- Makes
- 1
- Views
- 962
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Kitchen
- License
- Creative Commons — Attribution — Noncommercial
This is a simple spinning base for a decorating cake stand!
The intention of the print is to attach it to the bottom of a food-safe plate or dish rather than placing food directly onto it.
Note that this print requires a 8mm x 22mm x 7mm (ID, OD, Thickness) bearing, which should be pretty standard to find (I bought a pack of these: https://www.amazon.com/dp/B0872ZT4JY?psc=1&ref=ppx_yo2ov_dt_b_product_details)
There are two sizes (120mm works for a 6" cake, 180mm for larger), and a few different versions of each.
Disclaimer: I've only printed the “min_120mm” to save filament and to test its weight capacity. “Half” and “Full” tops will likely be sturdier than the one I tested, which is still pretty sturdy for a 6" cake.
Print Instructions
Print pieces in this orientation, flat side touching the print bed
4mm nozzle, 0.2mm layer height, 20% infill, standard PLA
Assembly Instructions
Step 1: Press the bearing onto the base piece until it clicks in
Step 2: Firmly press top onto bearing
Step 3: Tape/stick top piece onto food-safe plate/surface
Step 4: Center your “cake” and decorate!
