BambuLab AMS Riser with LEDs
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
My take on an LED riser. As with almost all of my designs: No Supports - No Hardware!
- Rating
- 4.833 / 5
- Likes
- 143
- Downloads
- 344
- Makes
- 5
- Views
- 8,329
- Reviews
- 6
Updated at source:
Model information
- Source
- Printables
- Category
- Bambu Lab Parts & Upgrades
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
There are a lot of these LED riser models for the BambuLab AMS. Several I REALLY liked, but didn't want to spend 2 hours at a hardware store searching for screws and nuts etc. I designed this one to be minimalist and printable on the X1 without supports and without hardware. This does take some soldering and wire-routing effort.
Print Left and Right in normal orientation. Print Center upside down. Supports wouldn't matter but its faster with the air holes on the bed.
Parts:
Dimmer Switch: https://www.amazon.com/Onsinn-Function-stepless-dimming-mounting/dp/B08W276JWS?th=1
LED Strip: https://www.amazon.com/dp/B0B1J8TQ8Q
6 pin Buffer to AMS cable from BambuLab Store
I printed mine in the PA-CF that came with the X1 Carbon. on 0.2mm layers with the “strong” profile. The foot pads were printed in general TPU.
Use a Multi Meter to make sure you get the pins and polarity right on the AMS wire. 1 ground 1 24v. The wire colors in the 6 pin cable were NOT standard. My yellow was 24vDC and red was ground (go figure).
Get started with cables here: https://wiki.bambulab.com/en/x1/troubleshooting/ams-power-failure
Update: Uploaded STEP File from FREECAD. The 4 bodys are in the 1 step file, the footpad is tucked under the riser leg with the power button as if it was installed. Be careful there. Enjoy and CAD responsibly :D