fountain pen revolution #6 nib unit pen body
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A fountain pen body that fits a fountain pen revolution #6 nib unit and standard international converter
- Rating
- 0 / 5
- Likes
- 12
- Downloads
- 83
- Makes
- 0
- Views
- 844
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Office
- License
- Creative Commons — Attribution — Noncommercial
This is a body that fits a fountain pen revolutions #6 nib unit. these are pretty inexpensive for standard sizes (broad through extra fine) and also fit their really nice ultra flex nibs.
There are left threads between the body and section. watch out for that.
The body is printed in PETG but PLA and works just as well.
There is a cap insert that should be printed in 95a TPU. this is what the pen body snaps on to when you put on the cap and will hopefully keep the nib wet. you should be able to push the insert into the cap with a chopstick, large flat allen wrench, or something else thin but not sharp. it will pop in place and anchor itself.
If it s too hard to push the pen into the cap with the insert you may need to sand the top of the section just a little.
print the parts standing open sides down with a brim
Print settings
body:
Prusa mini, PETG
0.15mm layer height
brim 5mm
no supports
insert
prusa min, Cheeta flex
0.15mm layer height
brim 5mm
no supports